Atlas
Axle Deadlift: starting position Axle Deadlift: end position

Hip Hinge · Lower back

Axle Deadlift

A hip hinge exercise that works the lower back. Intermediate level, using strongman.

The axle deadlift uses a thick, non rotating strongman bar about 2 inches in diameter, which makes gripping much harder. Because a hook grip is difficult, your forearms and hands work at their limit. It is a staple in strongman competition and a great option for intermediate lifters who want a stronger grip.

IntermediateStrongmanGym

Muscles worked

PrimaryLower back
SecondaryForearms, Glutes, Hamstrings, Traps & mid back, Quads

Lower back, glutes, hamstrings and quads lift the load as in a conventional deadlift. Forearms, traps and upper back work harder than usual to hold a thick bar that keeps trying to open your hands.

Setup and loading

Center the axle over midfoot with feet hip width apart and grip at shoulder width, double overhand or mixed if allowed. Expect to use noticeably less than your barbell deadlift, often 70 to 85 percent.

How to do the axle deadlift step by step

  1. Stand with the axle over the middle of your feet, touching your shins, with feet hip width apart.
  2. Hinge and grip the axle at shoulder width, wrapping your whole hand around it and squeezing hard.
  3. Lift your chest, lock your lats, and gently pull the slack out; breathe in and brace your abs.
  4. Push the floor away with your legs and bring the axle up close to your body, spine neutral and no jerking.
  5. Finish standing tall by extending your hips and squeezing your glutes while crushing the axle so it does not slip.
  6. Exhale and lower the axle under control by pushing your hips back until it rests on the floor.

Form cues

  • Crush the axle like you want to squeeze it
  • Pull the slack out before lifting
  • Keep the axle on your legs throughout
  • Finish with hips, not by leaning back

Common mistakes

  • Jerking the bar: the axle does not spin and rips from your hands; build tension first.
  • Gripping with the fingers only: your grip fails early; set the axle deep in the palm.
  • Loading like a barbell: grip limits you a lot; start much lighter.
  • Rounding the back as grip fatigues: end the set early; prioritize technique.

How to make it easier or harder

To make it easier, use straps to take grip out of the equation or start with a regular barbell deadlift. To progress, add load, do top end isometric holds with the axle, or pull from a deficit.

Advertisement

Sets and reps for your goal

Max Strength

4-5 x 3-6 · rest 2-3 min

3-6 sets of 1-6 reps at 80-90% of your max (1RM). Rest 2 to 5 minutes.

Leave 1-3 reps in reserve. If your technique breaks down, lower the weight: strength is built with good reps.

Endurance

2-4 x 15-25 or 30-60 s

2-4 sets of 15-30 reps or 30-60 seconds at 40-60% of your max. Rest 30 to 60 seconds.

Steady pace and clean technique to the end. Circuits help you build volume with little rest.

A guide for healthy adults. Adjust the load to your level and see a professional if you have an injury.

Check your form

Film yourself from the side or ask someone to watch, then tick what you get right.

0 of 4

Frequently asked questions

Why is the axle deadlift harder?

The axle is much thicker than an Olympic bar and its ends do not rotate. Your hand cannot close fully and hook gripping is awkward, so grip usually fails before your legs or back.

Can you use straps for axle deadlifts?

In training, yes, if you want to train the pull without grip limiting you. Many strongman contests allow straps in some events, but you should also train without them to build hand strength.

Sports it suits

Variations and similar exercises

Advertisement