Atlas
Machine Dip: starting position Machine Dip: end position

Vertical Pull · Triceps

Machine Dip

A vertical pull exercise that works the triceps. Beginner level, using machine.

The machine dip mimics a parallel bar dip, but you sit and press handles down against an adjustable weight stack. It lets you train your triceps with controlled loads without lifting your full body weight. It is ideal for beginners and anyone who cannot yet do bodyweight dips.

BeginnerMachineGym

Muscles worked

PrimaryTriceps
SecondaryChest, Shoulders

It is a pushing exercise where your triceps straighten your elbows, assisted by your lower chest and front delts. Keeping your torso upright puts more of the work on your triceps.

Setup and loading

Adjust the seat so your elbows sit at about 90 degrees when you grab the handles, without your shoulders shrugging. Use a moderate weight you can press for 10 to 15 full reps, always lowering under control.

How to do the machine dip step by step

  1. Adjust the seat and pick a moderate weight; sit back against the pad if the machine has one.
  2. Grab the handles with palms facing in or down and your elbows bent about 90 degrees.
  3. Pull your shoulders down, lift your chest, and keep your elbows pointing back near your body.
  4. Exhale and press the handles down until your arms are almost fully straight.
  5. Squeeze your triceps briefly at the bottom without snapping your elbows into lockout.
  6. Inhale and let the handles rise slowly back to 90 degrees, keeping your shoulders down.

Form cues

  • Elbows point back, close to your body
  • Shoulders down, away from your ears
  • Press down until nearly straight
  • Slow return, stop around 90 degrees

Common mistakes

  • Shoulders shrugging up: it stresses the joint; keep them down throughout.
  • Flared elbows: chest and shoulders take over; drive your elbows back.
  • Letting the handles rise too high: shoulder strain; limit range to about 90 degrees.
  • Leaning far forward: less triceps work; keep your torso upright.

How to make it easier or harder

To start, use light weight or do bench dips with your feet on the floor. To progress, add load, pause at the bottom, or move to assisted and then bodyweight parallel bar dips.

Advertisement

Sets and reps for your goal

Hypertrophy

3-4 x 8-12 · rest 60-90 s

3-4 sets of 6-12 reps (up to 15-20 on isolation exercises) at 65-80% of your max. Rest 1 to 2 minutes.

Get close to failure (0-3 reps in reserve) and control the lowering for 2-3 seconds. Accumulate 10-20 sets per muscle per week.

Max Strength

4-5 x 3-6 · rest 2-3 min

3-6 sets of 1-6 reps at 80-90% of your max (1RM). Rest 2 to 5 minutes.

Leave 1-3 reps in reserve. If your technique breaks down, lower the weight: strength is built with good reps.

A guide for healthy adults. Adjust the load to your level and see a professional if you have an injury.

Check your form

Film yourself from the side or ask someone to watch, then tick what you get right.

0 of 4

Frequently asked questions

Can machine dips replace parallel bar dips?

They train similar muscles and are a great alternative or stepping stone. Parallel bar dips also demand full-body stability and moving your own weight. If your goal is bodyweight dips, use both.

Do machine dips work the triceps or chest more?

It depends on your posture. With an upright torso and tucked elbows, your triceps do most of the work. Leaning forward and flaring your elbows brings in more chest.

Sports it suits

Variations and similar exercises

Advertisement